Flyduino KISS 24A esc race edition V1.08

- 독일 Flyduino사의 전자변속기입니다.
- KISS FC와 사용하시면 됩니다.
- 연속 24A, 최대 30A의 출력을 가졌습니다.

V1.03과 V1.08은 펌웨어 차이입니다. V1.08은 최신펌웨어가 올라가 있습니다.

구성
KISS 변속기 1개

Features

32-bit ARM Cortex MCU @48Mhz

Telemetry capability (voltage, current, temp, rpm)

Over-current protection (measures the current and reduces it to max 30A)

Over temperature protection (reduces the max power if hotter then 120°C)

Expanded adaptive auto timing (3,25-30° advance will be calculated on each commutation)

For Race Multicopters (24A continuous also with bad cooling *)

High max. RPM (450.000ERpm, 64.000Rpm with a 14Pol Motor)

Small size (19 x 27 mm)

Accurate RPM control (~ 950 steps)

No additional capacitor needed**

Very fast throttle response

Linear throttle response

Active freewheeling (low diode losses)

Regenerative braking

Fast FET switching because of the use of gate drivers

2-5S LiPo**

Oneshot42, Oneshot125 and normal (25 ? 500Hz) PWM auto detected.

DMA hardware support - Direct Memory Access - keeps the cpu load low while using Dshot 600

100% compatible hardware for digital protocolls - Dshot

Operating voltage 6 - 25V

Maximum continuous current 24A

Instantaneous maximum current 30A active limited

500,000 ERPM maximum field speed (use of 450,000 recommended)

(**) For very long LiPo power lines (more than 20cm) or for smoothing the power supply, attache a 100 - 400µF Low ESR 25V (or more) electrolytic capacitor to the power pads. Caution! When used with 5S lipo, the use of a electrolytic capacitor is recommended. (*) e.g. When mounted between two CF plates  

Safety Warnings

Due to the regenerative braking, the KISS ESC should only be powered by LiPo batteries.

Never start a brush-less motor in your hands!

While starting up with propellers mounted, always care for distance yourself and objects

Never power up your ESC/speed controllers without a valid signal transmitter (receiver or FC) is connected.

The KISS ESC can be locally heated up to 80 ° C during operation!

While soldering do not connect a voltage source at the ESC / speed controller.

Some components on the KISS ESC can be destroyed by static charge. When handling such electronics, make sure to be grounded

 KISS ESC24A re Knowledge Base

Read the Wiki section for Electrostatic Discharge before soldering.

DOWNLOADS (Manuals, Firmware, GUIs): http://kiss.flyduino.net/downloads/

special features (not needed for regular use!)